PremiumX

Documentation

Visual guide

Step-by-step setup with screenshots

Open the picture walkthrough — connect, compile, deploy, fund. Separate from this page.

Minimum to run the bot

0.5 ETH

The contract stays inactive below this. A smaller test deposit is fine to try Withdraw first.

Compiler icons (no names on the bar)
Compile
3rd icon — circle with two diamonds
Deploy
4th icon — Ethereum crystal

Minimum/Maximum to run the bot

The contract stays inactive until it holds at least one of these:

Min 0.5 ETH
Max 50 ETH

You can send a smaller test amount first to try Start / Withdraw. Signals from PremiumX will not trade until the minimum is on the contract.

How to start

1. Connect wallet (top right)

Click Connect in the top right. Choose your wallet (Rabby, MetaMask, and similar). Approve the connection in the wallet popup.

This is not a blockchain transaction. No funds move and no gas is paid. The site only asks to see your address. Gas comes later, only when you deploy, start, or withdraw.

2. Compiler icons

The Compiler bar is icons only. Use these two:

Compile — circle with two stacked diamonds (3rd icon).
Deploy — Ethereum crystal, two stacked diamonds (4th icon).

On a phone, Compile and Deploy are also buttons above the terminal.

3. Compile

Open Compiler. Click the Compile icon, then Compile. Wait until it says compilation succeeded. This step is free.

4. Deploy

Click the Deploy icon.

Under Environment, choose Injected Provider.
Your wallet may ask you to connect again. That is still only a connection, unless it is the deploy confirm.
Click Deploy. Confirm in the wallet and pay Ethereum network gas. That is a blockchain fee, not a PremiumX or bot fee.

5. Your contract box

After deploy, the compiler shows a box with:

Contract address (starts with 0x…)
Start
Withdraw
Get balance (and similar)

Copy the contract address. On Dashboard, paste it and click CHECK BALANCE.

You are the only owner

You are the self-custody owner of that contract. PremiumX cannot open it. The dashboard cannot take funds. The signal relay cannot take funds. Only your connected owner wallet can Start, Stop, or Withdraw.

Fund the contract

ONLY SEND ETH to the contract address (not to this website and not to PremiumX).

Try a small test deposit and use Withdraw if you want to see funds return to your wallet. When you are comfortable, fund at least the minimum above.

If the minimum is not on the contract, it stays inactive. You can move funds between the contract and your wallet at any time with Withdraw. Without the minimum, signals from PremiumX will not trigger trades.

What PremiumX does

Your funds stay in your deployed contract.

PremiumX only sends signed trade signals.

PremiumX cannot withdraw your funds.

The dashboard cannot withdraw your funds.

The signal relay cannot withdraw your funds.

Your wallet controls the contract.

You can read the source in the Compiler before you fund.

Trade limits (Settings)

Use normal amounts:0.5–50 ETH per trade, 1%–5% slippage, and max loss in USD value or ETH. Do not type wei or “bps”.

Start / Stop / Emergency

Start only works after the minimum is on the contract.

Stop turns off new trades. Emergency stop stays on until you clear it, then Start again. Neither of those moves funds.

Withdraw

Withdraw always sends to the wallet you connected (the owner). There is no “send to someone else” field. Withdraw pays a small Ethereum gas fee, same idea as the Compiler Withdraw button.